KÖPING S12CL

fernballan

H-M Supporter - Gold Member
H-M Supporter - Gold Member ($25)
Joined
Sep 24, 2017
Messages
398
I need to replace bearings in electric motors on my köping lathe
Almost all lathe manufactured in Sweden have birth certificates with all tolerances, when it was made and where it was sold. My lathe was manufactured 30/04 1964 and sold to lokstaverken.
He i bought the lathe off, used the lathe until the company went bankrupt
He bought the lathe of the company but never used it


DSC01113.JPG

DSC01112.JPG

DSC01111.JPG

DSC01110.JPG
 

Nogoingback

H-M Supporter - Gold Member
H-M Supporter - Gold Member ($25)
Joined
Oct 18, 2016
Messages
1,410
That's a great looking lathe fernballan, and I like the fact that you still have it's "birth certificate". How long have you owned
it?

Do you plan on changing those bearings soon?
 

fernballan

H-M Supporter - Gold Member
H-M Supporter - Gold Member ($25)
Joined
Sep 24, 2017
Messages
398
That's a great looking lathe fernballan, and I like the fact that you still have it's "birth certificate". How long have you owned
it?

Do you plan on changing those bearings soon?
I think I bought it four years ago I have 3 weeks of vacation now so i going to do it now
 

Nogoingback

H-M Supporter - Gold Member
H-M Supporter - Gold Member ($25)
Joined
Oct 18, 2016
Messages
1,410
That sounds like a good plan: I'm not sure I would want to run those bearings much longer. :)
 

NortonDommi

Brass
Registered
Joined
Nov 15, 2016
Messages
568
I hope the bearings are replaceable. A few German motors I have pulled down have had the inner race ground into the shaft. Basically throw the entire armature away and buy a new one at three times the cost of a new motor.
 

fernballan

H-M Supporter - Gold Member
H-M Supporter - Gold Member ($25)
Joined
Sep 24, 2017
Messages
398
I hope the bearings are replaceable. A few German motors I have pulled down have had the inner race ground into the shaft. Basically throw the entire armature away and buy a new one at three times the cost of a new motor.
I have talked to some friends and they bearing are replaceable Skickat från min F3111 via Tapatalk
 
Top