- Joined
- Dec 27, 2013
- Messages
- 44
Two, single bit lathe tool holders, one for the 12 inch, the other for the 6 inch. This type of holder has a recessed cotter that clamps
around the center post, it raises or lowers the bit centering it, using the hex head screw. When adjusted for the 3/8" bit ,on the Atlas,
it stays centered [same for the 1/2" bit, on the Grizzly,] Holder pivots and locks on center post with 1/4 turn of handle.
around the center post, it raises or lowers the bit centering it, using the hex head screw. When adjusted for the 3/8" bit ,on the Atlas,
it stays centered [same for the 1/2" bit, on the Grizzly,] Holder pivots and locks on center post with 1/4 turn of handle.
Last edited: