Good morning America
I am currently disassembling my new ally acquired logan 6560lh . Have back gear assembly,gear box, apron, removed, some things in apron don't look rite, worm gear severely worn and was difficult to remove.their was no key for shaft .shaft key aprox 3/16 but worm gear slot only 1/8".
not sure how clutch assembly functions, and how to identify how much wear is acceptable.
this is my first lathe rebuild . Any one out there familiar with this machine.
John1957
I am currently disassembling my new ally acquired logan 6560lh . Have back gear assembly,gear box, apron, removed, some things in apron don't look rite, worm gear severely worn and was difficult to remove.their was no key for shaft .shaft key aprox 3/16 but worm gear slot only 1/8".
not sure how clutch assembly functions, and how to identify how much wear is acceptable.
this is my first lathe rebuild . Any one out there familiar with this machine.
John1957
Last edited by a moderator: