Logan 820 rear take up nut

OK. Then that is different. Since you didn't explicitly say that the nut wasn't original, and it wouldn't be unusual for the designer to intend that covers be removed for what would be rarely done, I just assumed that it was. Despite what some of us seem to think, most of us really aren't smarter than the original designer. :cool:










o
 
That sounds like a lot of unnecessary work just to avoid removing the cover. Remove the cover, set the bearing pre-load to factory specs, and reinstall the cover. Check the preload maybe annually.


The Logans don't have a provision for preload adjustment since the preload is built into the chuck-side bearing. The only
reason I can think of to remove the nut would be to replace it with a spider.
 
Back
Top