Looking for change gears for Central Machinery 12x36 lathe Part #33274

Ok, now we are getting somewhere! I love this discussion. So the question still remains, where the heck do I get the change gears?

I attempted to figure out the pitch of the gears this morning and wasn't sure which answer was best. If I measured in inches, the pitch was 0.11. If I measured in MM it was 4.71 or supposedly 5. The gears indicate a M1.5 stamp with either 43 or 60 on them. I measured the gears at the centers in between the gears, multiplied them by 2 and then divided by the number of teeth on the gear. Does this seem correct?
 
If you know the modue and pressure angle you can find gear manufacturers on fleabay
 
You must log in or register to reply here.
Back
Top