Looking for Info on Fenn Transfer Punch Press

Ivan

Registered
Registered
Joined
Aug 11, 2013
Messages
10
Recently picked up a pair of Fenn transfer punch presses. One was still tooled from the last job, so I wired up and tested it out. It was set-up to make 3/8" ferrules, spits out two per second. Built in Hartford Connecticut, I was wondering if anybody knew anything about them. Thanks!

IMG_4104.JPG

IMG_4096.JPG

IMG_4100.JPG

IMG_4101.JPG

IMG_4102.JPG

IMG_4106.JPG
 
I have a book listed in another part of the forum on punches and dies from around WW2 if you are into the subject matter.
 
Sounds interesting, so how much are you asking for it? You also mentioned trades, is there something you have in mind?
 
Sounds interesting, so how much are you asking for it? You also mentioned trades, is there something you have in mind?

I paid $15 to rescue it from a used bookstore. Would like to at least get that back. But I do need a Machinery's Handbook. But i am ooen to other stuff like tooling or other machining books. I think the authors signature and the war supplement make it even cooler!
 
Last edited:
Ivan, BTW, I am a graduate of WMU even though I am from Maryland. Go Broncos!
 
Back
Top