Looking for small nylon gears and wiring diagram on maximat 7

I sent the STL file that middle.road found to a friend and he 3D printed one. He said it took about 45 minutes.

I still need to catch up with him to get it, and clean it up, and mount it on the three dot post/bearing to see how it goes.

He works at a commercial, custom stair manufacturer near here. Both of our schedules are crazy busy, but as soon as I can get to it I'll update you on the results.
Tumbler_Gear copy.jpg
 
Looks great -- do you know what kind of filament he used?
 
Just picked up a Maximat 7 .. headstock gear box was dry (UGGG).. cleaned out the grime and running a quick rinse of oil.. plan to change it again after a little motor time.. WHo thought to put the drain plug BEHIND the chuck... fortunately the chuck came right off.
The tool post/top slide is broke.. someone attempted a repair, if you can call it that.. So I'm looking for a replacement or alternative.
This is my first lathe.. The two small gears on my lathe are metal, perhaps someone had them made?
Would like to source an extra belt and the three nylon power feed gears.. Anybody?
 

Attachments

  • IMG_20220430_150909125.jpg
    IMG_20220430_150909125.jpg
    64.2 KB · Views: 93
  • IMG_20220430_150922625.jpg
    IMG_20220430_150922625.jpg
    49.8 KB · Views: 95
Back
Top