Low profile 6" chuck for rotary table

litewings

H-M Supporter - Silver Member
H-M Supporter - Silver Member
Joined
Dec 23, 2019
Messages
121
Just started my search for a low profile chuck to fit on my newly acquired rotary table. Table is 8" with four slots. Used or reasonable priced new is what I'm looking for. Want the low profile to conserve on mill z travel needed and less weight to deal with. Found this in a quick search


This would be great but this is way over what I want to spend since it will be used very little.

Open to suggestions
 
Following along to see what you come up with. I agree with @benmychree, it's going to be in stock for a long time.
 
I think that I first saw that chuck a good 25 years ago; it was outrageously priced than, and things have not changed since then.
 
Will probably still be on the shelf when alien archeologists discover it. Mike
 
I don't see many cheap low profile chucks. They must not lend themselves to cheap production or the market would be full of them. Dave
 
Back
Top