M1 Garand enbloc clip loader

sd624

Active User
Registered
Joined
Dec 15, 2012
Messages
150
I finished up the M1 clip loader project I've been working on. Not really gun smithing but gun related and tons of machining. Still need to Parkerize it.

yteqazuv.jpg
6aty6y9e.jpg
dygumumy.jpg
zynu4eqa.jpg

Here's a video of it in action.
http://youtu.be/_CLvnLgDOWs
 
Wow, looks nice, you must load the M1 clips quite often.. A video would be nice...
 
Thats slickern deer guts on a doorknob.





And it even right side loads the clip!

Nice job!
 
Enbloc loader

I was wondering if you had plans for the enbloc loader or did you ad lib the build, reverse engineer an original, or copy the oak version dimensions.

I would like to build one for myself and plans would be a good starting point and save me a lot of engineering and development time.

Thanks for any help you can render.

Peter Karis III
 
There's a link to the original prints in the comments section of the above YouTube video. I made many subtle changes from the original to make it easier to build. Be aware Ray's prints are full of mistakes so study them close before you start.
 
There's a link to the original prints in the comments section of the above YouTube video.

I looked for the link and did not see it. Can you p0st it please.

Thanks
 
Back
Top