Made one bad decision, trying avoid 2nd.

davek181 said:
I have a PM 30MV which is similar size, and I am loving it. I am a novice but learning slowly and enjoying the mill life a lot. i have a Atlas/craftsman lathe too, so I have both machines. Sometimes the lathe is handier for some operations, and the mill for others.

I had wanted the 728VT but at the time the wait was longer but I did want the Taiwan build. You will love it i am sure once you start making chips.
Click to expand...
I looked at the PM30, the DRO version is in stock too. I almost went that route. Definitely a nice piece of equipment…
Thanks..
 
Got my mill setup, the DRO and power feed install was simple and straightforward…

The pre-drilled holes and bracket set makes is simple. Took all of about 3 hours for the DRO and 1/2 hour for the PF unit.

Top notch equipment..
 
Can anyone tell me how much width one needs for a PM728v-t with the x-axis powerfeed installed? I have max 72". Thanks!
 
You must log in or register to reply here.
Back
Top