Micromark 7x16 Lathe Drive Belt

Sk8ter

Active User
Registered
Joined
Mar 31, 2013
Messages
79
belt has seen better days its been 5 years or longer on it and its time to replace....I have searched to no avail!

what have you guys done to replace it?



Lawrence
 
Little machine shop might have something that will fit. If not, I would just measure it and search for something equivalent.
 
Thanks I have searched little machine shop and online...the belt is 1.5x100x9
seems no one has it
 
You may be able to find a kit on E-bay that replaces both cogs and the belt, and reduces speed for more torque. I just did that conversion on my Harbor Freight 7x10/12. That would maybe result in a more commonly available belt to boot.
 
You may be able to find a kit on E-bay that replaces both cogs and the belt, and reduces speed for more torque. I just did that conversion on my Harbor Freight 7x10/12. That would maybe result in a more commonly available belt to boot.


Yes I have looked at those kits on ebay they will fit the 7x10 12 and 14 but not the 16 because I think its a different dia motor shaft etc...
 
Sk8ter,

Does that belt from LMS fit the Micromark or was that a dry hole?

Tom
 
Hello Tom sorry for the late reply....yes it fits fine....it was cheaper then what micromark wanted too
 
Back
Top