might make a GREAT score........maybe

[tfleming]

Mr. Fleming, did you ever tear down this power feed you purchased a year ago?
I have one on my mill also. Just curious

Yes, and I cleaned and lubricated all the gears and the clutch. I also purchased a replacement controller board from H&M. Works like a champ. I used high pressure, molybdenum disulfide military grade grease in it instead of the seals and gear oil (so I didn't have to worry about leaking oil into the DC motor). The old seals were OK, but I decided to go with the moly on the gears and clutch.

 

[mmcmdl]

MMCMDL, any chance I could get a few dimensions off of you so I can duplicate it? The 2 dimensions I am really looking for are, overall length, and the diameter of the support arm end (and length of that diameter).

Just saw this ! I'll get that for you if you still need them .