Mill accessorys for the beginner (Rotary / Angle Table)

8” vertex , I made the top fixture plate for it mic6 1-1/4” , old pic but table served me well.
Mt3 center 3/8” dowel centers the table on mill
Nice to know it’s there when needed.
O yaa
457D0F55-6474-4249-9350-3975B4BB67C7.jpeg
 
I use my mill a lot. Had the indexing head on the other day to cut a spline. Been a few years since it had been mounted to cut some gears. Im sure the rotary table was on a while ago but I can't remember what for. On the rare occurrence that I need an angle plate which I don't have I use a home made fixture plate with one end in the vice and the other end held up with a machinist jack.
Wait and see what you really need.

Greg
 
Back
Top