Mill motor recommendations and sources

@mksj It appears you have a good handle on the TECO L510 and I have a question I hope you can answer. My setup is running great, but I'd like to know how to manipulate the analog output. i.e I'd like to send a negative output to complete the circuit on my digital rpm gauge so it turns on when I kick on the VFD. Any advice? There are other ways of doing this, but I would like to know what these analog/digital outputs are and how to manipulate. I have the manual and I see they are all under group 4, but I see nothing like, "send - signal to S4" etc....
 
Back
Top