- Joined
- Nov 7, 2017
- Messages
- 17
Hey guys so looking for some help.....basickly I have a piece of titanium .160 thick bu 1.5in wide and 10 inches long. So I want to mill 1 half of it down to half thickness so one end of this bar will stay at .160 and the other half will be milled down to .08 I have a 2 in indexable end mill to accomplish the job...so I just started and I tried to go at a normal speed feed rate , a VERY slow feed rate even taking thin cuts at once or deeper cuts but no mater what I did it was throwing sparks everywhere until I just called it and stoped I was using a lil kool mister for lube but I think I may need a flooder to keep the sparks down does any one here know any decent flooders at a decent price or any sugestions would be appreciated! Thanks guys