ML7 missing parts

martik777

Active User
Registered
Joined
Apr 19, 2011
Messages
1,135
I'm not too familiar with these so not sure what parts are missing other than a gear box and motor and a few gears. I would be using this as a 2nd op lathe so gear box not needed. I could easily setup a variable power feed on the leadscrew and make a collet chuck to fit the spindle.

 
Those bedways look very good.
I've never seen a Myford in the flesh but it appears to have a clutch on the countershaft which is a nice feature.
As a 2nd operation lathe you could do a lot worse.
YMMV...
 
Back
Top