Monarch 10ee round dial Repair

Thanks for the compliment. I spent 2 weeks prepping for paint. Monarch uses a mechanical tach. Bob
 
Wow!! That's going to be one pretty machine! You're going to shame me into to painting mine...lol.

Chuck
 
nice work vettebob!
is that brushed on or sprayed?
 
It is automotive single stage urethane paint sprayed on with a hvlp paint gun. Bob
 
003.JPG001.JPGside at 12 inches.JPGtop at 12 inches.JPGtop at headstock.JPGI haven't posted anything for a while here's my progress. I installed removed and scraped the bottom of the headstock 20 times. My final results are .00027 down and .0001 towards the operator at 12". Taking test bar sag of .00017 into account that puts the headstock within .0002 over 12". Bob

003.JPG top at 12 inches.JPG top at headstock.JPG 001.JPG side at 12 inches.JPG
 
I ground the tailstock base and installed bronze shim stock. The base was worn .026 with most of the wear at the front.001.JPG
Rebuilt the worm gear. The internal key was worn by over .060 and the gear had .020 oval wear inside. I bored the gear to .874 then took a piece of .875 by .065 wall tube bored it to .753 and cut a 3/16 key way in it. The new feed shaft is .749. The key was welded to the sleeve then the sleeve was pressed in with locktite 609 bearing adhesive. I will drill and install a set screw on each end the weld the screw to prevent movement.001.JPG002.JPG004.JPG006.JPG

001.JPG 001.JPG 002.JPG 004.JPG 006.JPG
 
Lovely job! I am sure you mentioned how you painted the lathe but I missed it. Did you spray it or roll / brush it?

Paul.
 
Back
Top