Monarch 10EE steady Rest clamp domed washer

Brulow

Registered
Registered
Joined
Jun 23, 2013
Messages
9
Help!
Can anyone give me the dimensions for the Monarch 10EE Steady Rest clamp domed washer.
Called Monarch yesterday, they want $56 for one. At that price I'll try to make one. I was lucky enough to find a picture of one
Thanx.
Bruce

steady rest washer.jpg
 
Hi
I hope this helps
IMG_0486.JPGIMG_0487.JPGIMG_0488.JPG

Good luck show us how did you make the washer

Paul

IMG_0486.JPG IMG_0487.JPG IMG_0488.JPG
 
Thank You Paul,
I will try to make from your measurements, if possible could you give me the measur from the flat side of the washer to where the dome starts, also the radius of the dome ?
if so would be greatly appreciated.
Thank You.
Bruce
 
Hi I was trying to get a better photo and measure the angle but is not uniform rise it seems to rise the gets a bit flatter to the top 15-17 degree slope from the bottom
here is few more photos
So this is just the beginning of the slope I already posted the total thickness
IMG_0489.JPG

and profile
IMG_0497.JPG

I hope this help
Paul

IMG_0489.JPG IMG_0497.JPG
 
Thank You Very Much Paul.
will let you know how it works out.
Bruce




Hi I was trying to get a better photo and measure the angle but is not uniform rise it seems to rise the gets a bit flatter to the top 15-17 degree slope from the bottom
here is few more photos
So this is just the beginning of the slope I already posted the total thickness
View attachment 56992

and profile
View attachment 56993

I hope this help
Paul
 
Hi Paul,
this is how I did it, used the wire gadget to get the profile from the clamp, then with your meas,
the profile, and a few files this is what I got.
Thanx again.
Bruce

washer.JPG
 
Back
Top