I'm having some kind of mental block...
For my homemade wiper motor mill power feed, the motor (12V DC) that has three terminals.
I'm going to run power to it from a PWM controller with a reverse switch (this thing: )
Here's the behavior:
I can't figure out how to wire the switch, assuming I need a 6 terminal DPDT?
Also does it say anything that it draws less current going CW vs CCW?
Thanks in advance!
-John
For my homemade wiper motor mill power feed, the motor (12V DC) that has three terminals.
I'm going to run power to it from a PWM controller with a reverse switch (this thing: )
Here's the behavior:
I can't figure out how to wire the switch, assuming I need a 6 terminal DPDT?
Also does it say anything that it draws less current going CW vs CCW?
Thanks in advance!
-John