Need help on a chuck arbor

[34_40]

I need a arbor for a drill chuck, Morse Taper 2 with the chuck end threaded male 3/4-24 and the other end threaded 3/8 coarse female for the drawbar.

I've been searching but don't seem to be able to nail one down. Maybe one of you guys have seen one? TIA

 

[woodchucker]

I think you should go the route I did.
You can cut the 3/4-24 single point. The tapers are excellent. So were the threads for the draw bar.
https://www.hobby-machinist.com/threads/great-mt2-blanks-for-my-8520.68020/

 

[Ulma Doctor]

3/4- 24 tpi????
i have not run across that before

i totally forgot about the other thread @woodchucker , great stuff!

 

[34_40]

3/4- 24 tpi????

I think you should go the route I did.
You can cut the 3/4-24 single point. The tapers are excellent. So were the threads for the draw bar.
https://www.hobby-machinist.com/threads/great-mt2-blanks-for-my-8520.68020/

i have not run across that before

I don't have the chuck in my hand at the moment but I'm pretty sure that's what was written/marked on it.

Thanks for the link Woodchucker, I'll read up on it and maybe give it a whirl.. what could possibly go wrong?!?!? LOL..