- Joined
- Aug 27, 2014
- Messages
- 65
Sorry, my friends, somehow I was born with zero abilities in electrical matters.
My original motor of 25 years has burned out (Kunming 1.5HP). I found a new Baldor L1319M on eBay and got a good price.
There, that's the end of my electrical knowledge.
The old motor's junction box looked like this.
The four wires in the corners with the white sleeves are the ones coming from the lathe to the motor.
The new Baldor has 9 wires in the junction box. Two are unlabeled and have been joined together. The rest are labeled 1,2,3,4,5,J, and 8.
The picture on the junction box looks like this:
I need to run 230V, single-phase, reversing.
Here is a picture of the Wiring Diagram for the lathe.
Is that enough info? How do I twist together the new wires in the Baldor motor to connect to the wires Z2, V2, Z1, and U1 which go into the lathe?
I can run down more information if you need it.
I sure appreciate the help, I am dead in the water!
Thanks,
CannonFodder (Robert)
My original motor of 25 years has burned out (Kunming 1.5HP). I found a new Baldor L1319M on eBay and got a good price.
There, that's the end of my electrical knowledge.
The old motor's junction box looked like this.
The four wires in the corners with the white sleeves are the ones coming from the lathe to the motor.
The new Baldor has 9 wires in the junction box. Two are unlabeled and have been joined together. The rest are labeled 1,2,3,4,5,J, and 8.
The picture on the junction box looks like this:
I need to run 230V, single-phase, reversing.
Here is a picture of the Wiring Diagram for the lathe.
Is that enough info? How do I twist together the new wires in the Baldor motor to connect to the wires Z2, V2, Z1, and U1 which go into the lathe?
I can run down more information if you need it.
I sure appreciate the help, I am dead in the water!
Thanks,
CannonFodder (Robert)
Last edited: