- Joined
- Jun 26, 2018
- Messages
- 1,733
Hey all!
So I just got the lathe....cut the t-nut on the basic facing cut but I cannot figure out how to cut the nut without causing a collision for the stepped part of the operation. Probably need to do more basic stuff to learn this a bit more. Anyway, I know I haven't been here long but was hoping I could get someone to mill the step into this t-nut for me.
Thank you kindly!
So I just got the lathe....cut the t-nut on the basic facing cut but I cannot figure out how to cut the nut without causing a collision for the stepped part of the operation. Probably need to do more basic stuff to learn this a bit more. Anyway, I know I haven't been here long but was hoping I could get someone to mill the step into this t-nut for me.
Thank you kindly!