New lathe input

WVJIM

Registered
Registered
Joined
Oct 24, 2014
Messages
5
Going to buy a lathe. Looking at the Grizzly G4000 9x19. Anyone have any experience input on this lathe?
Comments appreciated....:anyone:
 
I had a G4000 until I sold it for a 12 x 36 Enco. It was a good machine out of the box and there are a lot of modifications that can be done to make it better. Check out Steve Bedair's site. IMOH you won't go wrong with this machine. Wish I had mine back when turning small diameter parts.

Tom S
 
Thanks for the input. I would like to have a bigger lathe but just don't have the room.
 
Don't apologize. Having a lathe of any size is better than not having one at all. :D

And welcome to the site!
 
Back
Top