Newbie SB 9A

F

Fulmor

Registered
Registered
Joined
Dec 14, 2018
Messages
5
Any thoughts about this lathe and tooling? Thanks for taking the time.

00Y0Y_lM7wFnQTab6_600x450.jpg

00O0O_5EFtoEKYkPP_600x450.jpg

00z0z_fMwX8Vdaisp_600x450.jpg

00u0u_3nKuoOPH43M_600x450.jpg

00v0v_8iIq8a8xbLu_600x450.jpg
 
Yeah, looks like a lot of good tooling, and the lathe "looks" to be in good condition. Are you thinking of purchasing it, or do you already own it?
 
Check the wear but it is very well tooled up . :encourage:
 
I don't see the drive system.....motor, countershaft, etc.
 
Fulmor said:
Planning to look at in on Monday
Click to expand...
He has the motor not shown in photo. In the photo it looks as if the 'cover' for the head is missing. Is this difficult to find on the used market? It does not come with a stand, any recommendations in this area? Thanks for the feedback.
 
Fulmor said:
He has the motor not shown in photo. In the photo it looks as if the 'cover' for the head is missing. Is this difficult to find on the used market? It does not come with a stand, any recommendations in this area? Thanks for the feedback.
Click to expand...


I don't see any missing covers. The cone pulley area is open on the 9A. The motor mounts behind the head with a flat belt drive. Make a sturdy stand and it should be ready to use.
 
Thanks I will let everyone know what I decided after viewing it tomorrow.
 
You must log in or register to reply here.
Back
Top