- Joined
- Mar 26, 2018
- Messages
- 8,354
Hi,
I was inspired recently to add a hold down or clamping fixture to my 10" Rotary Table.
The center hole is not a Morse Taper, just a hole.
In an effort to clamp a piece on the table, I would like to add an aluminum plate but I am not sure the best way to go about this.
Obviously to expedite table centering I would like to cut a standard taper of some sort to dial in center spindle on the Bridgeport Mill.
Based on this type of table, what would you do or what have you done to achieve my goals?
Thanks for the help.
Jeff
I was inspired recently to add a hold down or clamping fixture to my 10" Rotary Table.
The center hole is not a Morse Taper, just a hole.
In an effort to clamp a piece on the table, I would like to add an aluminum plate but I am not sure the best way to go about this.
Obviously to expedite table centering I would like to cut a standard taper of some sort to dial in center spindle on the Bridgeport Mill.
Based on this type of table, what would you do or what have you done to achieve my goals?
Thanks for the help.
Jeff