OLD SHELDON LATHE ASSEMBLY QUESTION

rkempf

Registered
Registered
Joined
Jan 19, 2019
Messages
5
Took my grandpa's lathe apart and moved it, it set for 2 yrs before I assembled it again. got it all back together but have an EXTRA! part. looking for some help to find where it goes.
Lathe IMG_0619.jpgsuspect areaIMG_0618.JPG
partIMG_0620.jpg

If anyone can help that would be great.
 
Could be the saddle lock?
 
Under front of carriage by rack.
 
If not there then check back side of carriage.at bottom edge..should be two bolts
 
You were correct Lordbeezer, front of carriage by Rack. Thx
 
Kool..now take it back apart.clean it up real good..oil the hell out of it.make some chips..you have a old but nice lathe..when clean and lubed all parts will move like melted butter
 
Yep that’s the plan, just wanted to make sure I could get it all together 1st, been a couple years since I took it all apart to transport it
 
You're on the right site to ask questions if you need help.lots of smart people here.everyone here like pictures..good luck..I have lots of kin in your area..
 
Take pictures when disassembly is going on.you'll be glad you did in a month or two goes by.
 
Back
Top