One last Modification on the GO727

The new location of the screw... to make the gears mesh properly, the new location must be in line with the shaft from the hand wheel, right? I assume the orientation of the shaft (that raises the knee) is set by the casting itself. And you made a longer shaft that placed the lead screw as close to the center of the table as possible. Let me know if I'm missing something.
 
Hi durableoreo,

Welcome to the forum. Not sure who you’re addressing your post to, but this thread is 7 years old and iron man hasn’t been seen here in almost a year. Just a heads-up in case you get no other responses.

Tom
 
OK. Too bad. Any chance we could re-name the thread to G0727 instead of GO727? It took a week of research to find this thread. I read OF it fairly frequently in other threads but could not find it. I had a good laugh when I realized the zero was replaced by a capital-oh.
 
Back
Top