part holder for compound slide of PM12x36

[thlee72]

I need to do some minor milling on my 12x36 lathe. I'm curious what others have done to set this up. I assume I need an angle bracket to hold my part, but I'm not sure the best way to attach this to the compound slide of the PM lathe. Any thoughts or suggestions?

 

[Ray C]

I need to do some minor milling on my 12x36 lathe. I'm curious what others have done to set this up. I assume I need an angle bracket to hold my part, but I'm not sure the best way to attach this to the compound slide of the PM lathe. Any thoughts or suggestions?

I have not seen any new-production units like that but all the older ones I've seen are attached by removing the QCTP and using the T-slot.


Ray