Got this Maxport 1992 Taiwan mill
Was in basement and has seen little use. For course it’s 3 phase. It is a step pulley head. So go rotary phase converter or VFD. Think VFD as will be able to vary RPM without changing belt. They look king of complicated to set up and don’t know if this 70 year old will be able to figure it out. What has been your experience if you have gone this route
Got the mill, Taiwan Kurt copy vice 5.5 inch, set of collets, two chucks One small one larger, 14 inch rotary table , need to sell that to big for my needs, and a couple of fly cutters. Need to add z glass scale I have an extra electronic box to add
thanks
Was in basement and has seen little use. For course it’s 3 phase. It is a step pulley head. So go rotary phase converter or VFD. Think VFD as will be able to vary RPM without changing belt. They look king of complicated to set up and don’t know if this 70 year old will be able to figure it out. What has been your experience if you have gone this route
Got the mill, Taiwan Kurt copy vice 5.5 inch, set of collets, two chucks One small one larger, 14 inch rotary table , need to sell that to big for my needs, and a couple of fly cutters. Need to add z glass scale I have an extra electronic box to add
thanks