PM 30 MV short drawbar

advmaker

Registered
Registered
Joined
Aug 5, 2019
Messages
47
I just set up my new pm 30 on a home made bench. Now I just can't attach any collet to it. The draw bar does not even reach the threads. Am I missing something obvious?

Sent from my ONEPLUS A5010 using Tapatalk
 
If it is like the PM-25, there is a little black cap on the top of the spindle that is retaining the quill spring. You need to take that off, put the drawbar on, then put the cap back on.
 
I took that cap off, that tightened drawbar a bit to get collet up a bit, then put the cap back on and did the normal way. What an amazing mill!

Tried both end mill and a fly cutter for facing.
fd8f4815edca3ede8b7c0309d911ffbf.jpg
4b21510ffca8c076a48c70b03c469b04.jpg


Sent from my ONEPLUS A5010 using Tapatalk
 
Back
Top