- Joined
- Oct 3, 2019
- Messages
- 3
Looking at a new mill to add to a workshop - I won't be the only user but I will be the shortest - at around 5'2"
I notice the Z height adjustment on this model is at the very top of the column and while it looks like it should be within reach, I'm not sure if actually using it with the PM stand from the front will be comfortable/practical
The scant diagrams in the manual aren't helping a lot with this either.
Has anyone on the shorter side used this with the provided stand and has any feedback on this?
I also noticed another user posted a PM-25 mod to drive the Z axis from a handle located at the front, which I may ultimately do, or look into a table with adjustable height.
I notice the Z height adjustment on this model is at the very top of the column and while it looks like it should be within reach, I'm not sure if actually using it with the PM stand from the front will be comfortable/practical
The scant diagrams in the manual aren't helping a lot with this either.
Has anyone on the shorter side used this with the provided stand and has any feedback on this?
I also noticed another user posted a PM-25 mod to drive the Z axis from a handle located at the front, which I may ultimately do, or look into a table with adjustable height.