PM 727 Power Feed vs X-axis ball oiler

Lefty Turner

Registered
Registered
Joined
Dec 26, 2011
Messages
6
Hello fellas. Long time lurker, but finally have a forum post! I recently installed the PM provided power feed for a PM 727 that I purchased last summer. Now that the power feed is installed, I noticed that the mounting hardware now covers access to the ball oiler on the left end of the x-axis. I can't tell from the parts diagram whether the ball oiler is keyed onto the x-axis shaft and I cannot rotate it for oiling, or whether in fact it will rotate. Is it a press-fit onto the x-axis shaft?

Thank you,
Lefty
 
Back
Top