Pm ultra precision drill chuck ???

Love it, silky smooth, no issues at all, but have not used it much yet.

David.
 
I have one for my mill and it is very nice. Jaws seem to work well and have had no slippage but I do tighten it with the spanner.

I use a smaller Albrecht more often but when the bigger capacity is needed, out it comes and does a fine job.

I bought it with my PM mill as part of the order.
 
Yea I'm looking to eventually upgrade from the janky loose one that cam with my mill
 
I have that, and it's smaller brother for my mill. They are silky smooth, and accurate. Use them all the time.

I even have one for my lathe. :)
 
I have two, one mt3 and a r8. I would buy one again. Both are very smooth and have held up to almost daily use for months now, bought my first one last October, still works great. I had no hesitation buying another one for the new mill, very nice chucks in my opinion.
 
I've been wondering about those chucks as well, good to hear only good things as I was looking at LLambrich which is a whole lot more $. As I just ordered a 935 I might add them to the order and save shipping. Thanks for starting the thread.
Alex
 
Thanks guys I'll add that to the never ending tool buy list lol
 
Found an old video, I just uploaded to YouTube, easier to post on the forum.

Watch "PM Drill Chuck" on YouTube
 
You must log in or register to reply here.
Back
Top