A
Alan H.
Forum Guest
Register Today
The maximum width that you can use on the PM1340GT is 15 1/2". So that is why the pan in the photo that kicked this thread off is a good choice for this lathe. It is also shallow enough to fit under the low bed height at the headstock end.I also use a baking sheet for my lathe, but I would think a plastic tray made for a dog's crate
would work too and you could probably get a single tray that would fit better. Here is one
that is around 30" x 18". The downside is that it is plastic. Not sure how well that would
hold up.
https://www.amazon.com/Precision-Pet-ProValu-Great-Replacement/dp/B004UMKY4Q/ref=sr_1_3?ie=UTF8&qid=1492190034&sr=8-3&keywords=dog+crate+tray&th=1