Pole mounts for new drill and old belt grinder.

th62

Active User
Registered
Joined
Aug 22, 2014
Messages
304
I have a smallish shed, 5m x5m so space is limited. halfway along either side wall is a 6" post that juts out the same amount, this precludes largish machines being placed in front. When last in Aldi I spotted a small bench drill which I though would do well next to the pedestal so I mounted the bench drill on a bracket I made that clamps around the pole. I also included a couple of stickouts on which to mount two drill sets.

While I was at it I made up a similar clamp for the other post and mounted the belt grinder I made a while back.

Both work quite well, free up bench space and use space not normally used.

P_20180924_205213[1].jpg

P_20180924_205150[1].jpg

P_20180922_021021[1].jpg

P_20180922_015411[1].jpg

P_20180922_005756[1].jpg
 
Looks great! And uses up unused space to boot. Would it be possible to see a close up of the belt grinder you've made? Looks nice!
 
Thank you so much! May have to copy you somewhat. When I get caught up......
 
Back
Top