Power feed help

DANNYBOY

Registered
Registered
Joined
Nov 14, 2012
Messages
46
Not sure if this is the correct place for this, if not please let me know.

My power feed has no speed adjustment. It still runs but at full speed. Is this something that can be repaired, I or just get a new one.


Thanks Danny KIMG0077.JPGKIMG0078.JPG
 
off the top of my head it would appear that the potentiometer or the wiring in the potentiometer circuit is faulty.
there is the potential for control board failure too.
crack it open, inspect it and look for broken or burned wires or connections.
my unit didn't work when i got it on my BP.
turns out there was a broken wire inside, a 2 minute solder repair saved a couple hundred bucks ;)
 
Is the rapid switch stuck?
 
Check the set screw that holds the speed knob on. I had one come loose and wasn't turning the shaft.
 
. Haha thanks all.
Knob is tight
Rapid don't appear to be stuck
I'll bust her open in a day or 12 lol

Thanks again
 
Awesome thanks pstemari, I honestly don't know why I didn't even think to Google a manual, That is usually the first thing I do. Haha brain fart I guess.

Thanks again
 
Back
Top