U
umahunter
Forum Guest
Register Today
Well lil over a month ago the collet stop screw on my mill sheared off and my drawbar was stripped no problem called pm they sent me a new drawbar said didn't need collet screw turns out that screw was the only thing allowing me to use the mill without the screw you couldn't tighten the collet just spins so after doing several tests figured taper wasn't ground right needed to be replaced pm doesn't carry this part so had to come from the factory so over a month of emailing back and forth have a mill I can't use and I sold my other mill like 2 days before this all happened so finally today a box shows up from china with random freaking parts not the part to repair my machine I need a new spindle and receive 2 handles a quill dro some electrical part couple face plates and an e stop button complete bs
EDITOR'S NOTE:
Matt from PM resolved this guy's problem as quickly as he could, to the satisfaction of the OP.
This is not made abundantly clear from the tone of the OP's post, but it is, in fact, what happens.
On H-M, vendors who provide excellent service are treated fairly by our staff, and our members.
EDITOR'S NOTE:
Matt from PM resolved this guy's problem as quickly as he could, to the satisfaction of the OP.
This is not made abundantly clear from the tone of the OP's post, but it is, in fact, what happens.
On H-M, vendors who provide excellent service are treated fairly by our staff, and our members.
Last edited by a moderator: