Put a ding in my mill table

[Jake2465]

Well, I finally did it... After almost three years of owning my mill I managed to drop a tool holder with a drill bit in it on the table. It put a pretty little ding there the size of a center punch hole... I shuffled over to my tool box and got out my stone and WD40...

 

[Cooter Brown]

Pictures or it didn't happen

 

[Jake2465]

Ima cover it up with the vice so no one sees it.

 

[fradish]

Actually as Cooter said, just don’t take a picture of it and it didn’t happen! I have to remember that trick!

 

[Jake2465]

Now every time I look at my mill table, I will see that ding and it will remind me of that treacherous #7 drill bit.

 

[tjb]

Now it's officially a piece of equipment instead of furniture. Congratulations.

Regards,
Terry

 

[BtoVin83]

Run a end mill into the table and you wont focus on that ding anymore

 

[Jake2465]

Run a end mill into the table and you wont focus on that ding anymore

That's kind of like when Major Payne broke that guys finger so he wouldn't think about his arm that got shot.

"Want me show you a little trick to get your mind off that ding? Here, gimme your end mill.. Now you may feel just a little bit of pressure."

 

[Janderso]

Where is the picture?
I have a table that looks like the moon

 

[Jake2465]

Ill put up a picture some time this week. It was pretty much a virgin mill table before the ding. Perhaps I should put on on the other side to even it up.