Rear Tool Post Parting Tool Holder

It is not just meant for South Bend. You can use it if it is close to the size of your cross slide. It said it will fit Logan and some other lathes. The casting has a lot of metal. Just check the size of your lathe and if it will work on yours.
 
NEL957 said:
It is not just meant for South Bend. You can use it if it is close to the size of your cross slide. It said it will fit Logan and some other lathes. The casting has a lot of metal. Just check the size of your lathe and if it will work on yours.
Click to expand...

Better yet. My lathe already has T-slots so no issues here but there are a lot of old lathes out there that would benefit from this mod.
 
Nicely done! Making your own tools that work better than expected is always satisfying. I like the etching as well.
 
You must log in or register to reply here.
Back
Top