Renegade Prints (build Has Begun)

Very nice. :aok:

Where did you source the balls?
 
Elevation Tower is next. 2.750 dia. 2.625 high. 1.000 thru hole and a tapped 3/8-24 side hole plus profiling. I know --- profiling is against the law.

"Billy G"
102_1050 (800 x 531).jpg
 
OD, height, starter hole and profile done. Need full bore dia. and threaded side hole then this part hits the tumbling barrel. Won't happen today, gotta start painting the rooms.

"Billy G"
102_1052 (800 x 531).jpg 102_1053 (800 x 531).jpg
 
1 inch bore complete. Just the 3/8-24 threaded hole to go. Paint no come in. Breaks my heart ( not)

"Billy G"
102_1054 (800 x 531).jpg
 
Tomorrow we start the bearing holder/elevation adj.

"Billy G"
102_1055 (800 x 531).jpg
 
Nice easy 2 hours. 1"-40 TPI single cut. All that is left on the Elevation Adj. Tower is the lock screw. Time for second coffee.

"Billy G"

102_1057 (800 x 531).jpg

102_1056 (800 x 531).jpg
 
Last edited by a moderator:
The beginning of the decorative locking screw. 3/8-24 die cut threads. The head will be pressed on and be held fast with lock tite when done. This bolt will serve two purposes one, to lock the adj. and two, it will serve as a reference point in making the adjs. A small flat (1/4 wide full length ) must also be cut on the bearing holder for this unit to work properly.

"Billy G"
102_1059 (800 x 531).jpg
 
Last edited by a moderator:
Your thoughts please. This looks about right for the larger diameter of the handle. It is just a couple of bushings pushed over each other. The final piece will be brass and fluted lengthwise, not knurled. Pic #! is 3/4 inch, pic #2 is 5/8 inch. Which one?

"Billy G"

102_1060 (800 x 531).jpg 102_1061 (800 x 531).jpg
 
Last edited by a moderator:
Back
Top