- Joined
- Nov 15, 2017
- Messages
- 15
There are two other stickers on the motor. One reads: 'No. 13206 0204105A'. The second one reads: 'Genie Co. E27607', although the E could be an F, the sticker is slightly damaged.
I should point out that a basic 48C motor would be a bit easier to mount, and an adapter plate would not be necessary. I just happened to find this particular motor. I would have far preferred to find a standard 48C frame. In fact, if I happen to fine one, I'll swap out the mill/drill motor next. I am in the process of fitting indicators to the X, Y, and Z now.
I should point out that a basic 48C motor would be a bit easier to mount, and an adapter plate would not be necessary. I just happened to find this particular motor. I would have far preferred to find a standard 48C frame. In fact, if I happen to fine one, I'll swap out the mill/drill motor next. I am in the process of fitting indicators to the X, Y, and Z now.