Rockford/Hedwick MV100 power table feed install

[Brucepts]

Added a 3d printed ring-light I designed, need to work on the design a bit more the column casting is oval. I'm not big on 3d design/print so each project is a work in progress

I used 2 halo led headlights one 125mm the other 145mm this has been a long term project I was going to make out of aluminum, then the 3d printer came along so I'm playing with the design on that . . .

 

[Brucepts]

Made another addition to the ole mill Monday, added a digital rpm meter to replace the non-functioning analog one that was there.

The cover of my mill was dropped at some point in it's life before I owned it and had been cracked and a large chunk was missing. I've had the parts to add the digital readout for a few years but never got around to installing it. I've been slowly picking away at small projects and this was one of those.

The magnet was only taped on for testing purpose it's now installed with bonding silicone adhesive. The slow range is stated as 80rpm and as you can see it was showing 81rpm. I did not run it up to all the range speeds yet for testing, I'll do that once I have the wires permanently mounted. I 3d printed the gauge mount