Rong Fu RF-31 RF31 Drum switch & motor wiring

[WERDI]

Hello to whomever may view this thread.

Does anyone have a picture of how the motor is wired for 230v as well as the wiring for the FWD - OFF - REV drum switch in 230v ?

I have followed the manual, and the motor box cover. Both have failed to resume this machines working capabilities. I must be missing something simple.

Thank you for all who assist.

 

[markba633csi]

Show some close up pix of the motor terminals and the drum switch, as detailed as possible. We can go from there
-Mark
They don't have to be super hi rez just close enough to see clearly-500K files are plenty good enough

 

[WERDI]

Show some close up pix of the motor terminals and the drum switch, as detailed as possible. We can go from there
-Mark

Thank you, I will do. About 10 mins

 

[WERDI]

Show some close up pix of the motor terminals and the drum switch, as detailed as possible. We can go from there
-Mark
They don't have to be super hi rez just close enough to see clearly-500K files are plenty good enough

 

[markba633csi]

I think I see the problem already- the #4 motor wire isn't connected, looks like the factory goofed up. I believe #4 should connect to the white
and the yellow is not used (for the 220 volt case)
If you want to be totally sure, I'll need to see the switch. Otherwise, go ahead and see if it works if you dare
-M
I'm signing off but I'll check back tomorrow

 

[WERDI]

I think I see the problem already- the #4 motor wire isn't connected, looks like the factory goofed up. I believe #4 should connect to the white
and the yellow is not used (for the 220 volt case)
If you want to be totally sure, I'll need to see the switch. Otherwise, go ahead and see if it works if you dare
-M
I'm signing off but I'll check back tomorrow

Removed the drum switch to reveal wire orientation for pics...

 

[markba633csi]

OK yes my previous post should get you going
-M

 

[WERDI]

OK yes my previous post should get you going
-M

So, leave the drum switch alone?
And just swap the specified wires on the motor?

 

[WERDI]

OK yes my previous post should get you going
-M

So this...?

 

[markba633csi]

Yes, and tape up that yellow one otherwise you'll have fireworks