I didnt think rotation direction would matter , but it doesn't hurt to ask
The welder is a Miller Sr-150-32 Cc 150 amps dc only .
I had to go to Cleveland last week and decided to stop at hgr surplus.
And couldn't pass it up for the huge price of $49 +tax
It didn't come with any of the tig welding stuff , but it did have 25 Feet of leads for stick welding with it .
Almost finished , I need to wire up an on/off switch for the pony motor and add a few cable clamps and I'll be all finished .
I did test it today , with no load I have 223v on L1. 246v on L2 and 233v on L3
I only added capacitance between L1 and L2 ( 138 uf )
I'm still unsure if I need to add it between L3 and L2 along with how much . I guess I'll see how the welder works before I get to worried about it .
Total cost so far using junk I've scavenged over the years .. maybe $130-$140 .
A bit ugly and mounted on a skid because I don't have a permanent spot for it yet
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.