SBL13 HS to TS Alignment

Bamban

Active User
H-M Supporter Gold Member
Joined
Jul 13, 2014
Messages
1,051
Turned down a dead center in the 4J combination chuck and installed a PTG one inch test bar between centers. Did not get any video of the initial test, the TS was 0.015 low, I kind of expected it for a 1956 lathe. Shimmed and adjusted the TS and took these videos.

Close enough for government work.
 

Attachments

  • 20181117_212241.mp4
    12.8 MB · Views: 21
  • 20181117_212152.mp4
    8.4 MB · Views: 13
Back
Top