Scored Punch Press

First picture is my lower plate holding my file shear.
Second picture is the upper die.Rubber press bender.JPGPress file shear.JPG
 
I'm not quite sure I understand your pictures. Could the 1st and second be reversed? Is this an anvil type shear as opposed to a bypass shear?
Thanks
Aaron
 
Your right... Some how the pictures got swapped... Yes it is a anvil type shear .
 
I made a shear using two old files. It sure is fast for shearing small parts. I make yarn racks
and i shear 1/2" cold roll round all day.
Just noticed photos. Did you have to temper the file?
 
I only ground an edge on it... I'm surprised the hammering that it takes without breaking.
 
Back
Top