- Joined
- Nov 14, 2014
- Messages
- 851
So, maybe an obvious question, but can you slot the inside Diameter of work with a shaper? If so, are there any restrictions on how deep into the bore one can go? The specific instance I am thinking of is making a set of 1" ID spacers that slip over an arbor for a horizontal mill. The spacers typically have a key way cut into the ID. At present I don't have a broach set and just missed buying a slotting head for my VN 12. So have no good way to cut inside diameter slots.
Maybe I need a broaching tool.....
Glenn
Maybe I need a broaching tool.....
Glenn