- Joined
- Jan 19, 2016
- Messages
- 5
So I've finally gotten around to needing to cut some threads on the lathe. The installation guide was fairly straight-forward and configuration of the gears was no problem. The issue I'm having is that when backing off the tool and reversing the handwheel direction, the arm holding the gears together is loosening and the gears slip. Sometimes it happens almost immediately and sometimes only after several cutting passes.
I'm wondering if anyone else has had this issue and what they've done to resolve it. I'm debating a couple of modifications but I don't want to do anything drastic because the arms have to support multiple gear configurations (which means a mod that doesn't block a gear today might tomorrow).
So far I've been thrilled with the lathe (4400) and all the other accessories. The thread cutter falls a bit short, with loose brackets, a cramped fit, and having to remove the motor.
Any suggestions appreciated. Thanks!
- Steven
I'm wondering if anyone else has had this issue and what they've done to resolve it. I'm debating a couple of modifications but I don't want to do anything drastic because the arms have to support multiple gear configurations (which means a mod that doesn't block a gear today might tomorrow).
So far I've been thrilled with the lathe (4400) and all the other accessories. The thread cutter falls a bit short, with loose brackets, a cramped fit, and having to remove the motor.
Any suggestions appreciated. Thanks!
- Steven