Show Us Your Shop Made Tooling!

Re: Shop made tooling

Thanks Paul. I'll look up the old posts and let you know if I have questions.

-Ron
 
Re: Shop made tooling

First a system for parting 125 mm steel in a 9 inch Boxford and then a tangential holder.
The tangential holder uses sticks between 4 and 5 mm square of carbide or stellite.(Tantung)

FarFar

Interesting tool cutter, got any more pics of the break down? Im interested to see how you have the tool bit held in there.
 
Re: Shop made tooling

No problem! :thumbzup:



The mount is actually fairly simple...

barrett_soft_mount.jpg

-Ron :p :lmao::lmao::lmao::lmao:

Ron
Im not a gun guy at all, but what kind of gun is that in the upper left hand corner ? (':biggrin:')

barrett_soft_mount.jpg
 
Re: Shop made tooling

Ron nice design, as was asked before have you drawn up the holder.
Here is my design after looking at your tool, but I'm worried about how much metal is in front of the leading tool edge if you get my drift.............
What did you allow,
finishedtoolholder01.jpg

Tangental Tool Holder.JPG Tangental Tool Holder 2.JPG

finishedtoolholder01.jpg
 
Re: Shop made tooling

Here's a couple of tools I've made.
The first is a couple of dimple dies I made a while back, I've made a couple of bigger ones as well.
dimple1.jpg
dimple2.jpg

And here's a jig I made for my rotary table.
DSC_02671024x685.jpg
DSC_02691024x685.jpg

dimple1.jpg

dimple2.jpg

DSC_02671024x685.jpg

DSC_02691024x685.jpg
 
Back
Top