Small dividing head restoration.

bob135

Registered
Registered
Joined
Jan 13, 2017
Messages
10
Hi Again, Heres one ive just finished over Christmas. My mill didnt come with the large dividing arm attachment like Deckels use so bought this Elliott dividing head cheap off ebay. It was all seized up and had 3 gears with broken teeth . I took the whole thing apart made 3 new gear replacements and cleaned it all up and paint it. The tailstock is the correct type but also bought seperately on ebay. Total cost for head and tailstock including shipping was £110.00 GBP. Its only 3 1/2" centre height but a good size fit for my Alexander mill.
Has an unusual split worm wheel inside the dividing head as well for backlash adjustment (the worm wheel is in two halves)
Bob

elliot 3 12.jpg

P1300515.JPG

P1300489.JPG

P1300516.JPG

P1300494.JPG
 
Back
Top